Vela 2000-0600, Инструкция по установке и эксплуатации

Страница: 45 / 179

Chapter 1 — Getting Started 35
Software Installation
• If you have not yet run the MFC update option for this release, check the
“MFC Update” checkbox on the “Select Components” screen. This step
needs to be done only once. If you check this box, there will be an extra set
of steps automatically included in the procedure specified below— and the
installation procedure will require an additional system restart. Just follow
the instructions presented by the MFCupdate.exe installation application.
• Under Required Components on the “Select Components” screen, check the
“Core Decoder Modules” checkbox.
• Click Next to proceed with the installation of the selected components.
• On the “Select Program Manager Group” screen (Figure 1-8), accept Vela
Research by clicking Next.
• On the “Start Installation” screen (Figure 1-9), click Next.
• A “DO NOT REMOVE THE CD” message box will display as a reminder
that a number of reboots may be required during the installation process.
Click OK to continue.
• If you have chosen to run the MFC Update option, the installation process
will begin here to copy files. Note: If you have not already done so, you
must run the “MFC Update” and “Core Decoder Modules” under Required
Components. These two check-boxes must always be checked when request-
ing the SDK —
This insures proper installation of the SDK .
• On the “Install” message box (Figure 1-10), note that the system must be
restarted. Click OK, and then wait as the system reboots. Leave the CD-
ROM in the drive through the system restart process.
5. If you remembered to leave the CD-ROM in the drive, the setup application
pops up immediately after the reboot. Continue with the installation by following
these steps:
• On the “CineCast End User License Agreement” screen (Figure 1-11), select
the “I Agree” radio button after reading the agreement. Then click OK.
The application will install some files.
6. If you elected to install the SDK:
• Select the “I Agree” radio button on the “CineCast SDK End User License
Agreement” screen (Figure 1-12). Click OK.
• On the Password screen (Figure 1-13), you will be asked for a password. Use
the one supplied when you purchased your Software Developer’s Kit. If you
have problems finding your password, contact Vela Support. After entering
the password, click OK. A few more files will be installed.