Millennia
Millennia Media, SPC.
6411 Capitol Avenue
Diamond Springs, CA 95619
https://www.mil-media.com
(530) 647-0750
Music
& Media Systems
Dante Option User Guide
revised 112621js
A Dante™ network is required to connect to.
Please refer to
https://www.audinate.com/resources/technical
-documentation
for the current Dante Controller
User Guide
.
Sample rates
up to 192kHz are supported by the
Dante option. The default is 48K. Use the Dante
controller software in your system to select the desired
sample rate.
Clocking
is determined by the Dante controller
software.
The Dante Option is a Tx (transmit) device only.
Primary Connection
–
Use this for the main Dante
network connection
Secondary Connection
–
Use this for
redundant network configurations. Do not mix Primary
and secondary connections within the same network.
Indicator LEDs
–
The left LED on the connector
indicates the connection is active and when blinking shows
the unit is active on the network. The right LED indicates
illuminates if the unit is connections to a 1Gbps network.
Off indicates it is connected to a 100Mbps network.
FCC Notice Information for the User
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with this instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at his or her own
expense.
Option
Supported
Latency Monitoring
Yes
Latency Range
150uS-5mS
Identify a device by flashing LEDs
No
Enable Sync to external Clock
No
Transmit Channels
8
Receive Channels
No
16 bit data
Yes
24 bit data
Yes
32 bit data
No
Option
Supported
Master Clock enable
Yes
Slave Clock enable
Yes (Default)
External Clock
No
Sample Rate Pull up/down
No
VLAN
No
Multicast
Yes
44.1K data Rate
Yes
48K data Rate
Yes (Default)
88.2K data rate
Yes
96K data rate
Yes
176K Data Rate
Yes
192K Data Rate
Yes
Redundant LAN
Yes (Default)
Switched LAN
Yes
Static IP
Yes
DHCP IP
Yes (Default)
Bit rate change without reboot
Yes
Per Channel Encoding
No
Device Encoding
Yes
Signal Metering
No
Unit Labeling
Yes
Channel Labeling
Yes
Supports 8 channels Tx /Flow
Yes
Up to 32 Unicast/Multicast Flows
Yes
