Ulvac VS1501, Инструкция по эксплуатации

Страница: 70 / 77

SK00-4390-DI-002-11
50
7. Removal / transport
7.1 Operation procedure
(1) Stop the Pump, and set the inside of the Pump to the atmospheric pressure.
(2) Shut the electricity supply and remove the cable connection.
(3) Please let cooling water run until the temperature of the pump falls after a stop.
(4) If the temperature of the pump falls, please close a supply valve of cooling water.
(5) Please take out cooling water from a pump and remove laying of the pipes.
(6) Please take out pump oil.
(7) Remove the Suction/exhaust piping and put Blind flanges to the Pump inlet and outlet to seal
them up
DANGER
Use of the toxic, combustible or combustion susceptible gas and
substance other than inactive gas is not allowed by the vacuum pump.
Pump oil as well as the Pump unit becomes toxic should the toxic gas
was sucked in the vacuum pump. Pay attention to execute maintenance
work.
You should replace with the nitrogen gas completely the Pump that
exhausted any special gas. Note further that only the entitled person for
special gas handling should be in charge of the removal work.
Keep applying a plate displaying the name of exhausted gas on a place
easily seen on the Pump.
WARNING
You have a risk of giving damage to your back as the load larger than
safety standard shall be required to transfer this product.
VS1501 : 232kg
VS2401 : 271kg
Be sure to use the loading machinery (such as mobile crane) to lift up the
Pump or load it on the pallet and fix it and run the Pallet truck for its
transfer.
Never try to enter beneath the Pump unit when lifted it up.
Use its top eyebolt to load/unload the unit.