Ulvac VS1501, Инструкция по эксплуатации

Страница: 16 / 77

SK00-4390-DI-002-11
xiv
Do not give the Pump a shock or lay it down. It might impair the Pump
operation.
Strictly refrain from putting any combustible substance in and around 1m
of the motor and Vacuum pump;there is a risk of getting a fire.
Do not put a wall or obstacle in and around 0.1m of the air inlet of the
motor (Motor edge face).
You have a risk of getting burned or fire caused by over heat.
Indoor use only
Install the machine horizontal to a place where there are less dust and humidity.
In case you fix the Pump to floor, fix the Pump to the floor with bolts at four places.
Fix the Pump horizontally so that there is not a wobble.
Refer to “3.1 Storage/ Installation”, too.
Model Foot print Bolt
Anti-vibration
Rubber mount
VS1501
VS2401
The Pump has four holes.
The Pump is fixed with four bolts.
More than
“M12 x 40mm”
Kurashiki Kako., Ltd.
Model
：
KLB-8030
(Recommended)
* NOT included
The detail of the holes position: Refer to the Fig. 2,3
0.6 Protective Device
This machine is equipped with the Three-phase AC motor.
This motor is not equipped with the protective device. Put an overload protective device to
connect through the motor with the Power Supply. It is imperative to put the overload protective
device under direction of the Electrical Installation Technical Standard (1965, Department of
Trade and Industry decree No. 61). Refer to “3. 6 Electric connection” to select the overload
protective device. It is recommended to put together another protective device such as a
leakage breaker
.
CAUTION