3.
Fill the tank to about 25 mm (1 inch) below the top of
the tank (bottom of the filler neck).
Do not overfill
.
4.
Install the cap.
5.
Wipe up any fuel that may have spilled, to prevent a
fire hazard.
Important:
Never use methanol, gasoline
containing methanol, or gasohol containing more
than 10% ethanol, because the fuel system could
be damaged.
Important:
Do not mix oil with fuel.
Checking the Level of the
Hydraulic Fluid
Service Interval:
Before each use or daily—Check the level
of the hydraulic fluid.
Important:
For accuracy, check the level of the
hydraulic fluid only when the engine and the hydraulic
system are cold.
The reservoirs of the machine are filled at the factory with
high-quality hydraulic fluid. The best time to check the
hydraulic fluid is when the fluid is cold. The machine should
be in the transport configuration. If the fluid level is below
the top of the horizontal part of the cut-out sight window on
the rear of the hydraulic reservoirs (
), add fluid to
bring the fluid to the acceptable level.
Do not overfill the
reservoirs.
If the fluid level is at the top of the horizontal
part of the sight window, no fluid addition is required. The
recommended replacement fluid is:
Fluid Type:
Toro Premium Transmission/Hydraulic Tractor
Fluid or Mobilfluid
®
424
Capacity:
•
Left side—1.9 L (2.0 US qt)
•
Right side—2.0 L (2.1 US qt)
Alternative fluids: If the specified fluid is not available, other
universal tractor hydraulic fluids (UTHF) may be used, but
they must be only
conventional, petroleum-based
products,
not synthetics or biodegradable fluids. The specifications
must fall within the listed range for all of the following
material properties and the fluid should meet listed industry
standards. Check with your fluid supplier to see if the fluid
meets these specifications.
Note:
Toro will not assume responsibility for damage
caused by improper substitutions, so use only products
from reputable manufacturers who will stand behind their
recommendation.
Material Properties:
Viscosity, ASTM D445
cSt @ 40°C (104°F) 55 to 62
Viscosity Index ASTM D2270
140 to 152
Pour Point, ASTM D97
-37°C to -43°C (-35°F to -46°F)
Industry Specifications:
API GL-4, AGCO Powerfluid 821 XL, Ford New Holland
FNHA-2-C-201.00, Kubota UDT, John Deere J20C, Vickers
35VQ25, and Volvo WB-101/BM
Note:
Many hydraulic fluids are almost colorless, making it
difficult to spot leaks. A red dye additive for the hydraulic
fluid is available in 20 ml (2/3 fl oz) bottles. One bottle is
sufficient for 15 to 22 L (4 to 6 US gallons) of hydraulic
fluid. Order part number 44-2500 from your Authorized
Toro Distributor.
1.
Look at the opening in each of the fluid-reservoir
brackets, and check the level of the hydraulic fluid.
Note:
The fluid level should be at the bottom of each
of the openings, as shown in
.
1
2
3
4
G023450
Figure 18
1.
Hydraulic-fluid reservoirs
3.
Bracket
2.
Fluid-reservoir cap
4.
Fluid level
2.
If the fluid level is low in either of the reservoirs, add
fluid as follows:
A.
Clean the area around the fluid-reservoir caps to
prevent debris from entering the system (
B.
Remove the caps from the reservoirs.
24
Содержание Sand Pro 2040Z
Страница 58: ...Notes 58...
