Figure 61
5.
Tighten the bolts and flange nuts to secure the handles
to the levers.
Adjusting the Control-Handle
Linkage
Turning the double nuts on the control-handle linkage allows
you to fine-tune the adjustment so that the machine does not
move in neutral. Make adjustments for neutral positioning
only.
WARNING
To adjust the control-handle linkage, the engine
must be running and the drive wheels must be able
to turn. Contact with moving parts or hot surfaces
may cause personal injury.
Keep hands, feet, other body parts, and clothing
away from rotating parts and hot surfaces.
1.
Park the machine on a level surface, turn the engine
off, remove the key, and set the parking brake.
2.
Raise all 3 wheels of the machine up off the floor, and
support the machine with jack stands just high enough
to allow the drive wheels to turn freely; refer to
the Machine (page 35)
.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the machine.
3.
Press down on the seat, or place a weight on the seat,
to press the interlock switch down.
4.
Start the engine and move the throttle lever to the Fast
position.
5.
Remove the pressure (or weight) from the seat.
6.
Release the parking brake.
7.
On 1 side of the machine, slowly turn the double nuts
on the linkage (
) until the wheel on that
side starts to rotate, then turn the double nuts in the
opposite direction until the wheel rotates in the other
direction.
Note:
The control handles need to be in the neutral
position while making any necessary adjustments.
1
G023650
Figure 62
1.
Double nuts
8.
Turn the double nuts back the other way until they are
at the
midpoint
between the 2 positions.
9.
Repeat steps
and
for the other side.
10.
Stop the engine.
11.
Remove the jack stands, and carefully lower the
machine to the ground.
12.
Start the engine again, and ensure that the machine does
not creep in neutral with the parking brake released.
47
Содержание Sand Pro 2040Z
Страница 58: ...Notes 58...
