Toro Sand Pro 2040Z, Руководство оператора

Страница: 41 / 60

Note:
Install the new filter with the arrow on the filter
body pointing away from the fuel tank (toward the
carburetor).
Electrical System
Maintenance
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Jump-Starting the Machine
1. Remove any corrosion from the battery terminals,
and ensure that the connections are tight before
jump-starting the machine.
Important:
Corrosion or loose connections can
cause unwanted electrical voltage spikes at any
time during the jump-starting procedure, which
could damage the engine.
Do not attempt to jump-start the machine if the
battery terminals are loose or corroded.
DANGER
Jump-starting a weak battery that is cracked
or frozen, or has a low electrolyte level or
an open/shorted battery cell, can cause an
explosion resulting in serious personal injury.
Do not jump-start a weak battery if these
conditions exist.
2. Ensure that the booster battery is a good, fully charged
lead-acid battery with at least 12.6 V. Use properly sized
jumper cables with short lengths to reduce the voltage
drop between the systems. Make sure that the cables
are color coded or labeled for the correct polarity.
Note:
Be sure that the vent caps are tight and level.
Place a damp cloth, if available, over the vent caps on
each battery. Be sure that the machines do not touch
and that both electrical systems are turned off and have
the same rated system voltage. These instructions are
for negative-ground systems only.
3. Connect the positive (+) cable to the positive (+)
terminal of the discharged battery that is wired to the
starter or solenoid as shown in
Figure 50 .
41