Toro Sand Pro 2040Z, Руководство оператора

Страница: 45 / 60

Drive System
Maintenance
Adjusting the Tracking
1. Drive to a flat, open area, and move the control handles
to the neutral-locked position.
2. Move the throttle midway between the Fast and Slow
positions.
3. Move both control handles all the way forward until
they both hit the stops in the T-slot.
4. Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward until the machine tracks
straight (
Figure 56 ).
•
If it tracks to the left, loosen the bolts and adjust
the right stop plate rearward until the machine
tracks straight (
Figure 56 ).
1 2
G023556
Figure 56
Left control handle shown
1. Bolt (4) 2. Stop plate
5. Tighten the bolts to secure the stop plate ( Figure 56 ).
Important:
Ensure that each control handle stops
against the stop plate and not against the transmission
internal stop.
Replacing the Drive Belt and
the Tensioner Pulley
1. Park the machine on a level surface, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
2. Raise the rear of the machine and support it with jack
stands; refer to
Lifting the Machine (page 35) .
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the machine.
3. Use a ratchet in the square hole in the tensioner arm to
counteract against the tensioner spring (
Figure 57 ), and
remove the belt from the tensioner pulley.
2 6 4 5 1
G023453
3
Figure 57
1. Left-hand transmission
pulley 4. Tensioner pulley
2. Tensioner spring 5. Engine pulley
3. Tensioner arm 6. Right-hand transmission
pulley
4. Unhook the tensioner spring from the tensioner arm
and the frame (
Figure 57 ).
5. Remove the nut that secures the tensioner assembly
to the frame (
Figure 58 ).
45