Toro Sand Pro 2040Z, Руководство оператора

Страница: 49 / 60

Adjusting the Engine Controls
Adjusting the Throttle Control
Proper throttle operation depends upon proper adjustment of
the throttle control. Before adjusting the carburetor, ensure
that the throttle control is operating properly.
1. Loosen the clamp screw securing the throttle-cable
housing to the engine (
Figure 66 ).
1
2
3
4
G023652
Figure 66
1. Clamp screw (choke-cable
housing) 3. Throttle-cable housing
2. Choke-cable housing 4. Clamp screw
(throttle-cable housing)
2. Move the throttle control forward to the Fast position.
3. Pull up the cable housing of the throttle cable ( Figure
66 ) until the throttle cable has almost no slack, and
tighten the clamp screw.
4. Tighten the clamp screw and check the engine speed:
•
High idle: 2750 to 2950 rpm
•
Low idle: 1450 to 1650 rpm
Adjusting the Choke Control
1. Loosen the clamp screw securing the choke-cable
housing to the engine (
Figure 66 ).
2. Push the choke control down to the Open position;
refer to
Choke Control (page 18) .
3. Ensure that the choke valve on the carburetor is fully
opened.
4. Pull up the cable housing of the choke cable ( Figure 66 )
until the choke cable has almost no slack, and tighten
the clamp screw.
5. Ensure that the choke valve moves to the fully closed
position when you pull the choke control outward and
to the fully opened position when you push the choke
control downward.
Adjusting the Engine Governor Speed
Control
WARNING
The engine must be running during adjustment of
the engine governor speed control. Contact with
moving parts or hot surfaces may cause personal
injury.
• Ensure that the control handles are in the
neutral-locked position, and set the parking
brake before performing this procedure.
• Keep hands, feet, clothing, and other body parts
away from any rotating parts, the muffler, and
other hot surfaces.
Adjust the low-idle speed as follows:
1. Start the engine and let it run at half throttle for
approximately 5 minutes to warm up.
2. Move the throttle control to the Slow setting.
3. Push the spring end of the governor arm downward
(
Figure 67 ).
1
G023671
Figure 67
1. Governor arm
4. Adjust the stop screw on the carburetor ( Figure 68 ) so
that the idle speed is 1350 to 1550 rpm.
Note:
Check the speed with a tachometer.
49