Toro Sand Pro 2040Z, Руководство оператора

Страница: 48 / 60

Adjusting the Control-Handle
Dampers
You can adjust the top damper-mounting bolt to change the
control-handle resistance.
1. To access the damper-mounting bolts, remove the bolts
that secure the stop plates to the frame (
Figure 63 ).
1 2
G023557
Figure 63
Left-hand side shown
1. Bolt (4) 2. Stop plate
2. Remove the locknut, move the damper-mounting bolt
to the desired position, and install the locknut. Refer to
Figure 64 for the mounting options.
Note:
Torque the locknut to 22.6 N-m (16.7 ft-lb).
The bolt must protrude past the end of the locknut
when it is tight.
Figure 64
Right-hand side shown
1. Locknut
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
3. Adjust the tracking; refer to Adjusting the Tracking
(page 45) .
Adjusting the Neutral-Lock
Resistance
If you prefer a different amount of side-to-side resistance in
the control handles when you move them into and out of the
neutral-locked position, you can adjust it as follows:
1. Loosen the jam nut ( Figure 65 ).
Figure 65
1. Flanged nut 2. Jam nut
2. Tighten or loosen the flanged nut to the desired feel.
•
For more resistance, tighten the flanged nut.
•
For less resistance, loosen the flanged nut.
3. Tighten the jam nut.
4. Repeat this procedure for the other control handle.
48