Toro Sand Pro 2040Z, Руководство оператора

Страница: 42 / 60

Figure 50
1. Positive (+) cable on
discharged battery 5. Booster battery
2. Positive (+) cable on
booster battery
6. Discharged battery
3. Negative (–) cable on the
booster battery 7. Engine block
4. Negative (–) cable on the
engine block
4. Connect the other end of the positive cable to the
positive terminal of the booster battery.
5. Connect the black negative (–) cable to the other
terminal (negative) of the booster battery.
6. Make the final connection on the engine block (not
on the negative battery post) of the machine with the
discharged battery, away from the battery, and stand
back (
Figure 51 ).
g0131 17
1
2
Figure 51
1. Engine block
2. Negative (–) cable
7. Start the engine, and remove the cables in the reverse
order of connection.
Note:
Disconnect the cable connected to the engine
block (black cable) first.
Replacing the Fuses
The fuse block ( Figure 52 ) is located near the control panel.
1 2 3 4
G023451
Figure 52
1. Lights (sold separately)
2. Attachment—10A
3. Engine start—25A
4. Battery—20A
To replace a fuse, remove it by simply pulling it out from the
fuse block, and install a new fuse
Important:
Always use a fuse of the same type and
amperage as the one you are replacing; otherwise, you
could damage the electrical system. Refer to the decal
on the back of the seat for the function and amperage
of each fuse.
Servicing the Battery
Charging the Battery
WARNING
Charging the battery produces gases that can
explode, seriously injuring you or bystanders.
Never smoke near the battery, and keep sparks and
flames away from the battery.
Important:
Always keep the battery fully charged. This
is especially important to prevent battery damage when
the temperature is below 0°C (32°F).
1. Charge the battery for 10 to 15 minutes at 25 to 30
A, or 30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, and disconnect the charger
leads from the battery posts (
Figure 53 ).
3. Install the battery in the machine and connect the
battery cables; refer to
Installing the Battery (page 44) .
42