Toro Sand Pro 2040Z, Руководство оператора

Страница: 46 / 60

2
1
G023551
Figure 58
1. Tensioner assembly 2. Nut
6. Remove the bolt securing the old tensioner pulley to
the tensioner arm, and install a new pulley (
Figure 59 ).
1
2
3
4
3
5
G023552
Figure 59
1. Bolt 4. Pulley
2. Spacer 5. Tensioner arm
3. Seal
7. Remove the belt from the transmission pulleys and the
engine pulley.
8. Install the new belt around the engine pulley and the 2
transmission pulleys.
9. Install the spring on the tensioner arm and the frame
(
Figure 57 ).
10. Use a ratchet in the square hole in the tensioner arm to
temporarily stretch the tensioner spring, and align the
belt to the tensioner pulley.
Controls System
Maintenance
Adjusting the Control-Handle
Position
There are 2 height positions for the control handles; high
and low.
1. Move the control handles to the neutral-locked
position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts that attach the handles
to the levers (
Figure 60 ).
Figure 60
1. Bolt 3. Lever
2. Control handle 4. Flange nut
4. Align the front-to-rear position of the handles by
bringing them together to the neutral position, and
sliding them until they are aligned (
Figure 61 ).
46