Thermo Scientific 410i, Инструкция по эксплуатации

Страница: 271 / 321

C-Link Protocol Commands
Calibration
Thermo Fisher Scientific Model 410
i
Instruction Manual B-31
o2 gas
This command reports the O
2
span gas concentrations used to auto-
calibrate O
2
coefficients. The example below reports that the O
2
span gas
concentration is 20.8%.
Send: o2 gas
Receive: o2 gas 20.8 %
set o2 gas value
This command sets the O
2
span gas concentration used by the auto-
calibration routine to value , where value is a floating-point representation
of the gas concentration in percent. The gas units are the same as those
chosen by the user. The example below sets the O
2
span gas concentration
to 20.8 %.
Send: set o2 gas 20.8
Receive: set o2 gas 20.8 ok
span cal reset
This command reports that the span cal reset is on or off. The following
example reports that the span cal reset is on.
Send: span cal reset
Receive: span cal reset on
set span cal reset onoff
onoff = | on | off |
This command sets the span cal reset to on or off. The following example
sets the span cal reset to off.
Send: set span cal reset off
Receive: set span cal reset off ok
span dev
This command reports the span deviation (span check offset). The
following example reports that the span deviation is 1 ppb.
Send: span dev
Receive: span dev 1.000 E+00
set span dev value
This command sets the span deviation (span check offset) to value , where
value is a floating-point representation of the gas concentration in current
selected units. The following example sets the span deviation to 345 ppb.
Send: set span dev 345
Receive: set span dev 345 ok