Thermo Scientific 410i, Инструкция по эксплуатации

Страница: 19 / 321

Thermo Fisher Scientific Model 410
i
Instruction Manual xv
Figures
Figure 1–1. Model 410
i
Flow Schematic ........................................................... 1-3
Figure 2–1. Remove the Packing Material ......................................................... 2-2
Figure 2–2. Removing the Shipping Screws ...................................................... 2-2
Figure 2–3. Model 410
i
Rear Panel .................................................................... 2-4
Figure 2–4. Atmospheric Dump Bypass Plumbing ............................................. 2-4
Figure 2–5. I/O Terminal Board Views ............................................................... 2-6
Figure 2–6. D/O Terminal Board Views .............................................................. 2-7
Figure 2–7. 25-Pin Terminal Board Views .......................................................... 2-8
Figure 3–1. Front Panel Display .......................................................................... 3-2
Figure 3–2. Front Panel Pushbuttons .................................................................. 3-2
Figure 3–3. Flowchart of Menu-Driven Firmware .............................................. 3-5
Figure 3–4. Pin-Out of Rear Panel Connector in Single Range Mode ............... 3-9
Figure 3–5. Pin-Out of Rear Panel Connector in Dual Range Mode ................ 3-10
Figure 3–6. Analog Output in Auto Range Mode ............................................. 3-12
Figure 3–7. Pin-Out of Rear Connector in Auto Range Mode .......................... 3-12
Figure 4–1. Calibration Flow Schematic ............................................................ 4-4
Figure 5–1. Inspecting and Cleaning the Fan ..................................................... 5-4
Figure 5–2. Cleaning or Replacing the Capillary ................................................ 5-5
Figure 5–3. Rebuilding the Pump (New Technology) ......................................... 5-8
Figure 5–4. Rebuilding the Pump...................................................................... 5-10
Figure 6–1. Board-Level Connection Diagram - Common Electronics ............... 6-5
Figure 6–2. Board-Level Connection Diagram - Measurement System ............ 6-6
Figure 7–1. Properly Grounded Antistatic Wrist Strap ...................................... 7-4
Figure 7–2. Model 410
i
Component Layout (Standard) ..................................... 7-7
Figure 7–3. Model 410
i
Component Layout (High Level) ................................... 7-8
Figure 7–4. Removing the Measurement Case Assembly and Lowering the
Partition Panel (410
i
Standard shown) ................................................................ 7-9
Figure 7–5. Replacing the Fan .......................................................................... 7-12
Figure 7–6. Replacing the IR Source ................................................................ 7-13
Figure 7–7. Removing the Motor (Standard) .................................................... 7-14
Figure 7–8. Removing the Motor (High Level) .................................................. 7-14
Figure 7–9. Replacing the Optical Bench (Standard) ....................................... 7-17
Figure 7–10. Replacing the Optical Bench (High Level) ................................... 7-17
Figure 7–11. Replacing the Optical Switch (Inverted View) ............................ 7-19
Figure 7–12. Replacing the Optical Switch (High Level) .................................. 7-19
Figure 7–13. Replacing the Detector/Preamplifier Assembly ......................... 7-22