58
/
167
Figure 84 Connect ports P, T, LS at the rear axle of agriculture machine to hydraulic valve
with oil pipe
Figure 85 Connect hydraulic valve and CVB module with oil pipe
Similar to the open center type agriculture machine, check the operating conditions of
steering system of the agriculture machine before installing hydraulic valve group.
After the hydraulic valve group is installed, check the operating condition of
hydraulic valve group.
4.4
Routing of Cables
After the installation of electronic assemblies, steering system and hydraulic valve
group, cables should be routed to complete the electrical connection between the
components and assemblies of autopilot.
The cables are routed around the Autopilot (Controller). The front panel of Autopilot
(Controller) is shown in the figure below.
