TERSUS AG960, Руководство пользователя

Страница: 84 / 168

83 / 167
battery

Check if the battery still has voltage (≥12V)

Replace the drive harness

Contact the distributor or FAE department of manufacturer.

During power-on, the LED light of gourd-shaped switch is ON while the LED
light of Autopilot (Controller) and the screen of panel computer both are OFF

Check if the battery still has voltage (≥12V)

Check if the drive harness (black end harness) and data harness (white end
harness) are inversely connected

Disconnect and reconnect the connection between the drive harness and the
Autopilot (Controller)

Replace drive harness

Replace Autopilot (Controller)

Contact the distributor or FAE department of manufacturer.

During power-on, both the LED light of gourd-shaped switch and the LED light
of Autopilot (Controller) are ON, while the screen of panel computer is OFF

Press the gourd-shaped switch to power on the equipment again

Disconnect and reconnect the connection between the data harness and the
Autopilot (Controller)

Disconnect and reconnect the connection between the data harness and the
panel computer

Replace data harness

Replace the panel computer

Replace Autopilot (Controller)

Contact the distributor or FAE department of manufacturer.
5.2 Check Program Version
Enter the main interface, first touch the topmost icon “Manufacturer information”
in the menu zone at the left side and a block pops out from the left upper corner
of the screen, as shown in the figure below.