160
/
167
time. If it is required to remove the glue and re-attach it, try to attach it at
the original location as far as possible. Otherwise it may cause falling
down from the cab top or damage of the radio receiving antenna.
Frequently check if there is any damage in the radio receiving antenna and
the cable. If any, contact the distributor to replace the component in time.
Otherwise it may cause the failure of equipment to receive the reference
station signals and then make the normal operation impossible. If the
replacement of component is caused by improper operation of user or
out-of-warranty period, the user should pay the purchasing cost of the
component and charges for the installation and commissioning service.
Maintenance of
panel computer
Frequently check if the connection between the back of panel computer
and the cable is loose. If yes, secure it in time. Otherwise it may cause
trouble in powering on the panel computer screen or communication faults.
Frequently check if two knobs of panel computer bracket are secure. If not,
tighten them in time. Or the panel computer may drop down and makes it
difficult to operate.
Frequently check if the screen or the body of panel computer is covered
with dust or mud. If yes, clean it immediately. Otherwise it may cause
ineffective touching operation of the panel computer.
Frequently check if the panel computer is stuck by any sharp object and
thus leave traces. If yes, contact the distributor to replace the component in
time to prevent any fault resulting in the failure of operation. If the
replacement of component involves the improper operation of user or
out-of-warranty period, the user should pay the purchasing cost of the
component and charges for the installation and commissioning service.
Maintenance of
Autopilot
(Controller)
Frequently check if the Autopilot (Controller) is covered by mud or if the
surrounding is too wet. If yes, clean the driving box promptly and make
sure the surrounding is dry. Check if the front panel of Autopilot
(Controller) is often kicked or impacted. If yes, take necessary protective
measures in time.
Frequently check if the connections between 3 RF plugs and RF cables at
the front panel of the Autopilot (Controller) get loose. If yes, tighten the
connection in time. Check if the cable root bears too much stress. If yes,
adjust the cable in time to reduce the stress.
Frequently check if the connections of vehicle standard 23-pin connector
and the equipment harness at the front panel of the Autopilot (Controller)
