34
/
167
Figure 43 Installation orientation of autopilot should be parallel to the vehicle (CORRECT)
Figure 44 Installation orientation of autopilot should be parallel to the vehicle (WRONG)
Select a relatively flat plane in the driving cab as the installation surface of the
Autopilot (Controller), for instance, the driving cab floor, the fender of left and right
rear wheels of the driving cab, rear wall of the driving cab etc. It should be installed
far away from the engine to the greatest extent and it is prohibited to install the
driving box directly onto engine components. The installation position should ensure
the driving box is not easy to be trodden on or hit by control stick. Sufficient space
should be reserved for the outgoing cable of Autopilot (Controller) (at least 10cm in
the outgoing cable direction of the Autopilot (Controller)). The installation position
should provide relatively large bending radius for the harness and ensure relatively
low stress at the end of the harness.
4.1.4.2
Fix Autopilot (Controller) at Specified Position
Connect the Autopilot (Controller) and its adapter plate with four cross countersunk
screws (M6×12). Then fix the adapter plate of Autopilot (Controller) to the
installation surface in vehicle driving cab with electric tool and 4 outer hexagon
self-tapping screws (ST6.3×19)
Installation orientation of autopilot is
parallel to the tractor
Installation orientation of autopilot is
parallel to the tractor
Installation orientation of autopilot is
NOT parallel to the tractor
Installation orientation of autopilot is
NOT parallel to the tractor
