37
/
167
4.2.1.1
Select a Suitable Sensor Seat Based on the Knuckle Flange
Type of the Tractor
Observe the shape and screw number of the flange of guide wheel knuckle. If the
knuckle flange is round and has three screws as shown in the figure below, use the
round flanged base of the sensor provided in the package. If the knuckle flange is
rectangle and has 4 screws, use the rectangle flanged base of the sensor provided in
the package. If it is neither type of the above mentioned (usually found in various
agriculture machine with two-wheel drive), refer to section of “Install steering system
of parallelogram type”.
Figure 50 Tractor knuckle and suitable sensor seat
4.2.1.2
Assembly of the Steering Sensor and Sensor Flanged Base
Select proper sensor flanged base and assemble the steering sensor and the sensor
flanged base with 5 cross countersunk screws (M4×8).
Figure 51 Assemble steering sensor and sensor flanged base
4.2.1.3
Assembly of the Steering Sensor and Sensor Flanged Base
Remove the screws on the knuckle flange of tractor guide wheel with socket spanner
