SuperFlow AutoDyn, Руководство оператора

Страница: 62 / 208

System Operation
Volume 1, 6/16/05
Section 6 - Page 9
Figure 6-6 All Wheel Drive
5. Get into the vehicle and set the handheld controller on the steering wheel (the rubber
bumper on the back will keep it secure). Unlock the parking brake.
6. Unlock the rolls using the “Roll lock OFF” command on the handheld controller.
7. Start the vehicle and let it run slowly in first gear to center the wheels on the rolls.
8. Allow the vehicle to coast to a stop.
9. Tighten the straps to prevent front and back movement of the vehicle on the rolls.
A suggested method for AWD dynos is to secure the rear crossed straps
tightly and the front crossed straps a little loose. Run the vehicle slowly
and adjust the front crossed straps until the vehicle tracks straight. Then
add the rear power straps.
10. Install exhaust extraction systems, cooling air blowers, and other supporting equipment as
required.
11. Install an engine speed pick-up and all desired sensors such as optical tachometer on the
wheel, temperature and pressure sensors. Verify that the cables stay well clear of hot or
rotating parts. Sensor cables touching hot or rotating parts may be damaged and could
lead to fire or loss of control.
12. Position the air temperature and humidity sensor near the engine air inlet (or ensure it is in
the normal location).
13. Warm up the vehicle (if necessary).
1
2
2