SuperFlow AutoDyn, Руководство оператора

Страница: 183 / 208

M a n u a l
AutoDyn
Section 20 - Page 12
AutoDyn manual 1174 Sect20.PM6.5, 05/1999
From Windyn:
Click on “ Calibrate ”, enter the new value of 500 lb.-ft
(680 Nm) and click “ OK ” followed by “ Done ”
6. The calibrated value should appear on the handheld and
Windyn displays. If this is not so, there may be something
binding or broken in the eddy current absorber or the load
cell. Contact SuperFlow Customer Service for assistance.
7. Remove the calibration weights one at a time, let the
reading stabilize each time, and check for linearity.
Linearity should be better than +/- 5 lb.-ft (7 Nm) of torque.
8. Remove the calibration arm from the absorber.
9. Perform an Autozero of Channel 2
10. Save the new calibration as follows:
From the handheld controller:
Select “ Configure ” (I-key) followed by “ Calibrate ” (B-key).
Press “ Save file ” (B-key). Press the “ Exit ” (E-key) twice to
return to the main menu.
value