SuperFlow AutoDyn, Руководство оператора

Страница: 44 / 208

I
N S T A L L A T I O N
Section 5 - Page 7
Bolt the sensor box onto the mounting plate on top of the pole (4 bolts).
Slide the ring to a comfortable grabbing height, typically about 4~6
inches (10~15 cm) below the bottom of the sensor box and secure the
ring with the set screw.
Verify that the cable hooks are installed on the bottom of the
back of the sensor box and that the two bolts are tight.
WARNING Do not connect the sensor box power cable until all steps are complete to 5.1.6.
The sensor box electrical cable which plugs into the bottom of
the sensor box must be connected to the “control box” plug on
the dynamometer connection panel.
5.1.4. Sensor Box Power
Do not connect the sensor box power yet.
The sensor box power input is selectable for 120VAC or
240VAC. The frequency can be 50 to 60 hertz.
Verify the voltage selector switch setting on the power supply
inside the sensor box:
Remove the 4 ” hex buttonhead screws attaching the panel with the AC
Power plug to the sensor box and slide out the power supply about 1 1/
2” (3 cm) until the red switch is visible. Check the switch setting.
• Other models: open the sensor box door using the special
key. The black selector switch is visible on the front of the power
supply. Check the switch voltage setting.
Power Supply