SuperFlow AutoDyn, Руководство оператора, Страница: 130 / 208

AutoDyn
Operators Manual
Section 9 - Page 10
CH9 AutoDyn Description of the Config File.fm
Channels 62, 64, 65, 67, 68 AxPrs1 - AxPrs5
These channels are expansion channels for pressure measurement.
They may be implemented by buying additional pressure transducers.
Filtering is set to 5 and zeroing is by command.
62 0.000 3.636 volts
0.000 100.00 psi [689.5 kPa]
64, 67 & 680.000 3.636 volts
0.000 150.00 psi [1034.25 kPa]
65 0.000 3.636 volts
0.000 200.00 psi [1379 kPa]
Channel 66 - Fuel P
Channel 66 is used to measure fuel pressure. It has a range of 0-300 psi
[2068kPa] . Filtering is set to 5 and zeroing is by command.
0.000 3.636 volts
0.000 300.00 psi
[2068 kPa]
Channels 69, 70 - Air1 P, Air2 P
Channels 69 and 70 measure air inlet or exhaust pressure. Filtering is
set to 5 and zeroing is by command.
0.000 3.636 volts
0.000 276.00 InH2O
[70 kPa]
Channel 71 - DifSen
Channel 71 is used to measure the voltage from the differential
temperature sensor. It is used in channel 75 to provide a temperature
reading in degrees F. Filtering is set to 7 and no zeroing is required.
Coefficients should not be altered.
0.000 4.096 volts
0.000 4.096 volts
Channel 72 and 73 - CtrlV2, and CtrlV3
Channel 72 and 73 display control voltages 2 and 3 from the WinDyn
sensor system. These are used primarily for diagnostics to track the
behavior of the control system or other parameters that may be mapped
to these channels. They are not normally used for any test applications.
Filtering is set to automatic and no zeroing is required. Coefficients are
set to 1.000 and should not be altered.
0.000 10.000 volts
0.000 10.000 volts