SuperFlow AutoDyn, Руководство оператора, Страница: 182 / 208

S
E R V I C E A N D C A L I B R A T I O N
Section 20 - page 11
From Windyn:
Select “ Calibrate|Channels ” from the main menu. A calibra-
tion dialog box appears. Scroll down the list until channel #2
(RolTrq) appears and select it. Click on “
Zero ” and “ OK ”.
4. Put the five 20 lb (9.1 kg) weights that come with the dyno
on the end of the 5-foot (1.524 m) long calibration arm. The
applied torque is then: 5.00 ft x 100 lbs = 500 lb.-ft (5 x 9.1
kg x 9.81 x 680 m = 244.9 Nm). Wait a few seconds for the
arm to stabilize.
5. Enter the correct calibration of 500 lb.-ft (680 Nm) for the
current torque on the handheld or from WinDyn:
From the handheld controller:
Select “ Configure ” (I-key) followed by “ Calibrate ” (B-key)
Select channel #2 (RolTrq) by pressing “ Edit ” (C-key), then
“ Select ” followed by “ 2 ” and “Enter” .
Choose “ Current value ” (C-key) and enter 500 lb.-ft (680 Nm).
Verify that your entry is correct and confirm by pressing “ Yes ”
(A-key). Press the “ Exit ” (E-key) twice.
A message will appear, asking to save the changes in the
calibration file on the harddisk of the computer. Do NOT save
the changes at this time, by pressing “
No ” (E-key).
Exit the Configuration mode by pressing “ Exit ” (E-key).