Design and function
54
Super-Vitesse CFS 3101, 3501 / Super-Vitesse CFS 3101 DO, 3501 DO 10.13
The sensor (1) monitors the position of the
cutting unit.
A light barrier monitors the position of the
individual cutting knives and the soiling degree of
the cutting unit. The light barrier consists of the
transmitter (2) and the receiver (3).
The following positions of the "Cutting Unit"
symbol are available on the control set:
"Cutting unit extended" position if the cutting
unit has been completely extended into the
conveyor duct.
"Cutting unit retracted" position if the cutting
unit has not been extended into the
conveyor duct.
"Cutting knife out" position:
as soon as a cutting knife evades to
the rear,
as soon as the cutting unit is heavily
soiled.
Fig. 21
5.4
Transport floor
The chains (1) of the transport floor are equipped
with U-sections (2) and ensure consistent
feeding of the loaded material when charging
and discharging. Automatic chain tensioners
tighten the chains.
The transport floor is driven hydraulically via two
feed gearings.
The control set serves to:
switch the transport floor on and off,
variably adjust the feed rate of the transport
floor. The controllable volume flow of the
hydraulic oil is 2-80 l/min.
reverse the feed direction of the transport
floor for a short time (max. 3 seconds), e. g.
to eliminate blockages occurred at the
dosing drums during discharge.
Fig. 22
5.4.1
Set feed rate of transport floor (easy-to-use control)
Observe the information in the chapter "Change feed rate of transport floor", page 110.
5.4.2
Set feed rate of transport floor (ISOBUS control)
The feed rate of the transport floor depends on the set filling degree. Observe the information in the
chapter "Pre-select filling degree of loaded material in cargo space", page 136.