SignaMax SC30010, Справочное руководство CLI

Страница: 300 / 671

Chapter 9
| General Security Measures
ARP Inspection
– 300 –
ip arp inspection
log-buffer logs
This command sets the maximum number of entries saved in a log message,
and the rate at which these messages are sent. Use the
no form to restore the
default settings.
Syntax
ip arp inspection log-buffer logs message-number interval seconds
no ip arp inspection log-buffer logs
message-number - The maximum number of entries saved in a log
message. (Range: 0-256, where 0 means no events are saved and
no messages sent)
seconds - The interval at which log messages are sent. (Range: 0-
86400)
Default Setting
Message Number: 20
Interval: 10 seconds
Command Mode
Global Configuration
Command Usage
◆ ARP Inspection must be enabled with the ip arp inspection command
before this command will be accepted by the switch.
◆
By default, logging is active for ARP Inspection, and cannot be disabled.
◆
When the switch drops a packet, it places an entry in the log buffer. Each
entry contains flow information, such as the receiving VLAN, the port
number, the source and destination IP addresses, and the source and
destination MAC addresses.
◆ If multiple, identical invalid ARP packets are received consecutively on the
same VLAN, then the logging facility will only generate one entry in the log
buffer and one corresponding system message.
◆ The maximum number of entries that can be stored in the log buffer is
determined by the
message-number parameter. If the log buffer fills up
before a message is sent, the oldest entry will be replaced with the newest
one.
◆
The switch generates a system message on a rate-controlled basis
determined by the
seconds values. After the system message is
generated, all entries are cleared from the log buffer.
Example
Console(config)#ip arp inspection log-buffer logs 1 interval 10
Console(config)#