SignaMax SC30010, Справочное руководство CLI

Страница: 175 / 671

Chapter 5
| SNMP Commands
– 175 –
by default (see the nlm command), but will not start recording information
until a logging profile specified with this command is enabled with the nlm
command.
◆ Based on the default settings used in RFC 3014, a notification log can
contain up to 256 entries, and the entry aging time is 1440 minutes.
Information recorded in a notification log, and the entry aging time can only
be configured using SNMP from a network management station.
◆
When a trap host is created with the snmp-server host command, a default
notify filter will be created as shown in the example under the show snmp
notify-filter command.
Example
This example first creates an entry for a remote host, and then instructs the
switch to record this device as the remote host for the specified notification
log.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#snmp-server notify-filter A1 remote 10.1.19.23
Console#
show nlm oper-status
This command shows the operational status of configured notification logs.
Command Mode
Privileged Exec
Example
Console#show nlm oper-status
Filter Name: A1
Oper-Status: Operational
Console#
show snmp
notify-filter
This command displays the configured notification logs.
Command Mode
Privileged Exec
Example
This example displays the configured notification logs and associated target
hosts.
Console#show snmp notify-filter
Filter profile name IP address
---------------------------- ----------------