SignaMax SC30010, Справочное руководство CLI

Страница: 105 / 671

Chapter 4
| System Management Commands
File Management
– 105 –
Example
This example shows the information displayed by the whichboot command.
See the table under the dir command for a description of the file information
displayed by this command.
Console#whichboot
File Name Type Startup Modified Time Size (bytes)
------------------------------ ------- ------- ------------------- ------------
Unit 1:
SC3-52T_V1.1.10.171.bix OpCode Y 2017-11-01 05:35:52 8622340
startup1.cfg Config Y 2017-11-01 05:26:35 2076
Console#
Automatic Code Upgrade Commands
upgrade opcode auto
This command automatically upgrades the current operational code when a
new version is detected on the server indicated by the
upgrade opcode path
command. Use the no form of this command to restore the default setting.
Syntax
[ no ] upgrade opcode auto
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ This command is used to enable or disable automatic upgrade of the
operational code. When the switch starts up and automatic image upgrade
is enabled by this command, the switch will follow these steps when it
boots up:
1.
It will search for a new version of the image at the location specified by
upgrade opcode path command. The name for the new image stored on
the TFTP server must be C-300-series.bix. If the switch detects a code
version newer than the one currently in use, it will download the new
image. If two code images are already stored in the switch, the image not
set to start up the system will be overwritten by the new version.
2.
After the image has been downloaded, the switch will send a trap message to
log whether or not the upgrade operation was successful.
3.
It sets the new version as the startup image.
4.
It then restarts the system to start using the new image.