SignaMax SC30010, Справочное руководство CLI

Страница: 601 / 671

Chapter 25
| IP Interface Commands
IPv4 Interface
– 601 –
Command Usage
◆
An IP address must be assigned to this device to gain management
access over the network or to connect the router to existing IP subnets. A
specific IP address can be manually configured, or the router can be
directed to obtain an address from a BOOTP or DHCP server. Valid IP
addresses consist of four numbers, 0 to 255, separated by periods.
Anything other than this format is not be accepted by the configuration
program.
◆
An interface can have only one primary IP address, but can have many
secondary IP addresses. In other words, secondary addresses need to be
specified if more than one IP subnet can be accessed through this
interface. Note that a secondary address cannot be configured prior to
setting the primary IP address, and the primary address cannot be
removed if a secondary address is still present. Also, if any router/switch in
a network segment uses a secondary address, all other routers/switches
in that segment must also use a secondary address from the same
network or subnet address space.
If bootp or dhcp options are selected, the system will immediately start
broadcasting service requests for all VLANs configured to obtain address
assignments through BOOTP or DHCP. IP is enabled but will not function until
a BOOTP or DHCP reply has been received. Requests are broadcast
periodically by the router in an effort to learn its IP address. (BOOTP and
DHCP values can include the IP address, default gateway, and subnet mask).
If the DHCP/BOOTP server is slow to respond, you may need to use the
ip
dhcp restart client command to re-start broadcasting service requests, or
reboot the switch.
Note: Each VLAN group can be assigned its own IP interface address. You
can manage the switch via any of these IP addresses.
Example
In the following example, the device is assigned an address in VLAN 1.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#
This example assigns an IP address to VLAN 2 using a classless network
mask.
Console(config)#interface vlan 2
Console(config-if)#ip address 10.2.2.1/24
Console(config-if)#