SICE S50A Mobile, Инструкция по эксплуатации

Страница: 63 / 174

S50A Mobile Operator’s Manual 63
Do not force the tightening! Once the reset has been executed, check, through the spindle carriage translation, the success
of the adjustment.
Should the carriage friction on the guide rails be too much, loosen the adjusting screws (6) previously tightened.
Then fully tighten the locking nuts (5), keeping the screws (6) still.
Tighten the 4 + 4 nuts previously loosened ( 3 & 4 )
Restore the electrical connection, then check the smoothness of the just adjusted carriage.
5. STORAGE
In case of long-term storage (3÷4 months) it is necessary to:
1)
Leave the machine in the same configuration used when closing it inside the van.
2)
Disconnect the machine from the mains.
3)
Grease parts which might be damaged if they dry out:
- guide rails of tool carriage
- guide rails of turntable trolley
- spindle shaft
- tool arm
4)
Empty the hydraulic control unit tank completely through the designated oil drain cap.
5)
Protect the whole machine against dust by covering it with a nylon cover.
To restart it after a storage period it will be necessary to:
1)
Re-insert the oil in the control unit tank.
2)
Restore the electrical connection.
6. SCRAPPING
When deciding to stop using this equipment, deactivate every connection to the power sources in order to render it
inoperative.
Since it is classified as special waste, dismantle it into homogeneous parts and dispose of them as required by law.
Dispose of the materials in the designated collection centres for polluting or non-biodegradable materials.
ENvIRONMENTAL INfORMATION
This product may contain substances that are potentially harmful to the environment and human health unless disposed
of properly.
The information provided below is intended to prevent these substances from being released into the environment, and
to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste but must be separately
collected for proper treatment.
The barred bin symbol affixed on the product and shown in this page is meant to remind users that the
product must be disposed of properly at the end of its life cycle.
This prevents the inappropriate disposal of the substances contained in this product, or the improper
use of parts of this product, and the resulting hazards for the environment and human health.
It also helps to ensure that many materials contained in this product are recovered, recycled and
reused.
To this end, manufacturers and dealers of electrical and electronic equipment maintain special systems for the collection
and disposal of such equipment.
At the end of the product life cycle, contact your dealer for information about disposal procedures.