Sharp PN-80TC3, Руководство по обслуживанию

Страница: 76 / 210

PN-L803C/80TC3 SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4- 10
■ Error message
- Could not save. Drive has no free memory.
There is only no availability which saves the user settings at
USB flash drive
- USB not recognized. Check the connection.
USB flash drive cannot be recognized (mount failure)
- Failed to save file.
The format of USB flash drive is outside correspondence
The file name which it tries to write in overlaps
Writing is not made by write-protection etc.
Abnormalities occur at the time of other writing
6 – 7. USER SETTING VALUE PRESERVATION
TO USB FLASH DRIVE
■ USB flash drive
Use the USB flash drive corresponding to the following
standard.
- Format : FAT32/FAT16 (Upper limit of the cluster size : 32KB)
- USB : 2.0/1.1
<CAUTION>
・
It does not correspond to SD card reader.
・
It does not correspond to USB HUB
・
Don
’
t use the USB flash drive enciphered
・
Set the proper volume label name.
・
When the model name is changed right before this procedure,
turn OFF and ON the main power.
■ User setting value backup
1) Press [ENTER] key in "SAVE/RESTORE SETTINGS
VALUE" of SERVICE MENU3. The following screen is
displayed
2) If a cursor is united with [SAVE] and press [ENTER] key,
Select the item to save and press [ENTER] key.
ALL Almost all preset values are saved except a setup
changed by the state of a main part.
Information which is not saved
- IP address of LAN
- The preset value etc. which change with input
signals, such as a clock and a phase
PICTURE
ONLY
Only setup of image adjustment is saved.
3) Connect USB flash drive to the monitor
4) If a cursor is united with [Yes] and press [ENTER] key,
preservation will begin.
5) If preservation is successful, it will return to SERVICE MENU.
The file of [XXlog_(model name)_(serial number)_(time).dat] is
created by the root directory of a USB flash drive [Model name]
folder.