Assembly and installation
34
03.00 | ORG | Assembly and Operating Manual | en | 389246
Adjustment triple jaw B stroke
Both counter set screws (3) must be loosened before adjusting
the stroke of triple jaw B! They must be unscrewed from the
stroke adjustment ring (4) until the ring (4) can be turned!
The stroke of triple jaw B can be adjusted after both counter set
screws (3) have been loosened.
Ø
The stroke of triple jaw B is performed by adjusting the stroke
adjustment ring (4). The stroke of triple jaw B is increased by
turning the stroke adjustment ring (4) clockwise.
Ø
The stroke of triple jaw B is reduced by turning the stroke
adjustment ring (4) counterclockwise.
Ø
After the desired stroke has been set, the stroke adjustment
ring (4) must be secured against unintentional turning using one
of the two counter set screws (3) (depending on the angle of
turning, it may not be possible to clamp both set screws against
the base body triple jaw B.
Ø
If the stroke adjustment ring (4) cannot be turned despite
loosening the counter set screws (3) proceed as follows:
Repeatedly actuate triple jaw B open and closed.
Subsequently, the stroke adjustment ring (4) should be able
to be easily
rotated by hand again.
CAUTION
Carefully tighten the counter set screw using only your hand. If
it is tightened too much, assembly group 1 may become
jammed as a result
80].
Ø
Proceed as follows if triple jaw B does not open up after turning
the stroke adjustment ring (4):
✓
Disconnect gripper from the energy supply
✓
Loosen the counter set screws (3)
✓
Slightly turn the stroke adjustment ring (4) in the direction
opposite to the one last rotated
✓
Retighten the counter set screws (3)
