Assembly and installation
28
03.00 | ORG | Assembly and Operating Manual | en | 389246
NOTE
The dimension t must be at least larger than the tip of the gripper
finger (dimension r) plus two safety distances (dimension s). A
reliable assembly process is guaranteed if the safety distance
(dimension s) is set as small as possible (value range s =
0.1 mm < s < 0.3 mm).
✓
When the triple jaw B is closed, the segment jaws must be
joined to one another at a defined distance (dimension t).
✓
The circumferential circle of the three segment jaws
(dimension Øp) must be smaller than the inner diameter d
2
of the seal.
✓
When the triple jaw B is closed, the segment jaws must be
joined to one another at a defined distance (dimension t).
NOTE
Further information on the assembly and function of the product
from chapter
Function diagram external assembly
49].
