Assembly and installation
03.00 | ORG | Assembly and Operating Manual | en | 389246
25
Ø
Screw the gripper fingers onto the base jaws using one / two
M-3 screw(s) each.
Ø
In doing so, observe the following:
Detail
Settings of the gripper fingers and segment jaws
✓
When the triple jaw A is open, the gripper fingers must be
outside the seal at a defined distance (dimension o) from the
seal.
NOTE
The dimension t must be at least larger than the tip of the gripper
finger (dimension r) plus two safety distances (dimension s). A
reliable assembly process is guaranteed if the safety distance
(dimension s) is set as small as possible (value range s =
0.1 mm < s < 0.3 mm).
✓
When the triple jaw B is closed, the segment jaws must be
joined to one another at a defined distance (dimension t).
✓
The circumferential circle of the three segment jaws
(dimension Øp) must be smaller than the inner diameter d
2
of the seal.
✓
When the triple jaw A is closed, the gripper fingers must have
moved far enough inwards that the seal lies cleanly around
the segment jaws and is slightly stretched in the area of the
gripper fingers.
NOTE
Further information on the assembly and function of the product
from chapter
Function diagram external assembly
49].
