Samsung Ubigate iBG2016, Руководство по настройке

Страница: 539 / 744

Ubigate iBG2016 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
485
(Continued)
Step Command Purpose
8 timing {wait-
wink|wink-
wait|wink-
duration|delay-
duration|delay-
start } timing-value
To change timing parameters.
wait-wink - Specifies maximum amound of time to
wait wink for Outbound Call
wink-wait - Specifies maximum wink-wait duration, in
milliseconds, for a wink-start signal
Valid entries are from 100 to 5000. The Default is 200
wink-duration - Specifies maximum wink-signal
duration,in milliseconds, for a wink-start signal
delay-duration - Specifies the delay signal duration for
delay-dial signaling in milliseconds. Valid entries are
from 100 to 5000. The default is 2000
delay-start - Specifies minimum delay time, in
milliseconds, from outgoing seizure to outdial address.
Valid entries are from 20 to 2000. The default is 300.
9 timeouts timer-
name timer-value
To change timeouts parameters
initial - Sets the number of seconds that the system
waits between the caller input of the initial digit and the
subsequent digit of dialed string.
A valid entry is from 0 to 120. The default is 10
interdigit - Configures the number of seconds that the
system waits after the caller has input the initial digit or
a subsequent digit of the dialed string. If the timeout
ends before the Destination is identified, a tone sounds
and the call ends. This value is important when using
variable-length dial peer destination patterns(dial
plans). The
seconds argument is the interdigit timeout
wait time in seconds.
A valid entry is an integer from 0 to 120. The default is 5.
ringing - Specifies the duration that the voice port
allows ringing to continue if a call is not answered.
The range is from 0 to 60000.
The default is 180. 0 means infinity
wait-release - Specifies the duration that a voice port
stays in the call-failure state while the device sends a
busy tone, reorder tone, or an out-of-service tone to the
port.
The range is from 0 to 3600. The default is 30. 0 means
infinity.