Samsung Ubigate iBG2016, Руководство по настройке

Страница: 543 / 744

Ubigate iBG2016 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
489
(Continued)
Step Command Purpose
6 timeouts timer-name timer-
value
To change timeouts parameters
initial - Sets the number of seconds that
the system waits between the caller input
of the initial digit and the subsequent digit
of dialed string.
A valid entry is from 0 to 120. The default
is 10
interdigit - Configures the number of
seconds that the system waits after the
caller has input the initial digit or a
subsequent digit of the dialed string.
If the timeout ends before the Destination
is identified, a tone sounds and the call
ends. This value is important when using
variable-length dial peer destination
patterns(dial plans).
The
seconds argument is the interdigit
timeout wait time in seconds. A valid entry
is an integer from 0 to 120.
The default is 5.
ringing - Specifies the duration that the
voice port allows ringing to continue if a
call is not answered.
The range is from 0 to 60000.
The default is 180. 0 means infinity.
wait-release - Specifies the duration that a
voice port stays in the call-failure state
while the device sends a busy tone,
reorder tone, or an out-of-service tone to
the port.
The range is from 0 to 3600. The default
is 30. 0 means infinity.
7 timing wink-wait timer-value Sets the maximum time to wait before
sending wink signal after an incoming
seizure is detected
8 timing wink-duration timer-value Sets the duration of a wink-start signal