Ross Carbonite Black Series, Руководство по эксплуатации, Страница: 54 / 64

Resume — enter the bank ( Bank ) and
custom control ( CC ) you want to resume
• Cancel
— use the
Bank
knob to select the
custom control bank, and the CC knob to
select which custom control to cancel Cancal
— enter the bank ( Bank ) and custom control
( CC ) you want to cancel
• CancelAll
— press the
CancelAll
knob to
insert a cancel all custom controls command
Cancel All — insert a cancel all custom
controls command
•
State — press the Insert knob to insert the
state State — insert the switcher state
4. Press the Insert knob to insert the event. Click
Insert to insert the event.
5. Press START/STOP . Click Stop Recording .
Running a Custom Control
Once a custom control has been programmed, you can
run that custom control by pressing the button that the
custom control was recorded to.
Keep the following in mind when running custom
controls:
• A custom control will continue to run until it
reaches a hold event, is stopped by another custom
control, you edit a custom control, or the custom
control reaches the end.
• When a custom control is running, the button on
the custom control bus is red.
• When a custom control is held (at a Hold event),
the button on the custom control bus flashes white.
• You can run multiple custom controls at the same
time. The number of running custom controls
is shown on the display when in custom control
mode.
• You can stop a running custom control by pressing
the red custom control button on the custom control
bank.
• You can stop all running custom controls by
selecting a custom control with no events recorded
to it.
• A maximum of 128 custom controls can be run at
the same time.
To Run a Custom Control
Once a custom control has been recorded, you can run
that custom control at any time.
1. Press MENU . Click Navigation Menu >
Custom Control > Shot Box .
2. Select the bank that the custom control you want
to run is on by pressing the bank button.
3. Select the custom control you want to run by
pressing the source button on the custom control
bus. Click a custom control button to run that
specific custom control.
The custom control starts to play immediately.
Editing a Custom Control
After you have recorded a custom control, you can
go back and edit that custom control to add or remove
events.
Tip: Custom controls can also be edited from the Custom
Control node in DashBoard.
To Edit a Custom Control
When editing a custom control, you can delete and
insert events at any point in the custom control, or
append events to the end.
Tip:
When editing a custom control, press
RUN EVENT
to
run the currently selected event. This can help you diagnose
problems in a custom control.
1. Press MENU > BANK 1 > EDIT .
2. Use the Bank knob to select the bank that the
custom control you want to record will be stored
on, or select the bank button directly.
3. Use the CC knob to select the custom control that
you want to edit, or select the custom control on
the bus directly. The custom control will have an *
next to the number.
4. Use the Func knob to select where and how you
want to edit the custom control.
•
Edit
— select the position in the custom
control to edit events
• Append — add events to the end of the
custom control
5. Press the Func knob to start editing.
Tip: You can also start editing a custom control by
pressing and holding
EDIT
and selecting the bank and
custom that you want to edit to.
The display changes to show the name and
duration of the custom control, and the currently
selected event in the custom control.
6. Delete an event in a custom control as follows:
a) Use the left knob to select the event you want
to delete. You can also use the PREV and
NEXT buttons.
b)
Press DELETE .
54 • Custom Controls — Carbonite Black Operation Manual (v14.0)