Remote Control Commands
R&S
®
NRPxxTWG
63
User Manual 1178.8371.02 ─ 04
[SENSe<Sensor>:]AVERage:TCONtrol
<mode>
Defines how the measurement results are output. This is called termination control.
See also
Chapter 7.5, "Controlling the Measurement"
Parameters:
<mode>
MOVing | REPeat
MOVing
Outputs intermediate values to facilitate early detection of
changes in the measured quantity. In the settled state, that
means when the number of measurements specified by the
average count has been performed, a moving average is output.
REPeat
Specifies that a measurement result is not output until the entire
measurement has been completed. This means that the number
of measurement cycle repetitions is equal to the set average
count. If the average count is large, the measurement time can
be very long.
The average count is set using
*RST:
REPeat
Example:
AVER:TCON REP
[SENSe<Sensor>:]AVERage[:STATe]
<state>
Available in continuous average mode.
Enables or disables the averaging filter.
Parameters:
<state>
*RST:
ON
7.8.2
Setting the Frequency
The frequency of the signal to be measured is not automatically determined. For ach-
ieving better accuracy, the carrier frequency of the applied signal must be set.
[SENSe<Sensor>:]FREQuency
<frequency>
Transfers the carrier frequency of the RF signal to be measured. This frequency is
used for the frequency-response correction of the measurement result.
The center frequency is set for broadband signals, e.g. spread-spectrum signals, multi-
carrier signals.
Parameters:
<frequency>
Range:
0.0 to 110.0e9
*RST:
50.0e6
Default unit: Frequency
Configuring Basic Measurement Parameters
