Remote Control Commands
R&S
®
NRPxxTWG
91
User Manual 1178.8371.02 ─ 04
SYSTem:PRESet
Triggers a sensor reset.
The command essentially corresponds to the
*RST
command, with the exception that
the settings of the following commands are persistently held:
INITiate:CONTinuous
SENSe:AVERage:TCONtrol
Usage:
Event
SYSTem:REBoot
Reboots the sensor.
Usage:
Event
SYSTem:RESTart
Restarts the firmware of the R&S NRPxxTWG.
Usage:
Event
SYSTem:RUTime
<update_time>
Effective only in the NRP legacy mode.
Sets the result update time. That is the maximum rate in which the power sensor can
output measurement results. Relevant only in continuous measurement mode
(
ON).
Parameters:
<update_time>
Range:
0.0 to 10.0
*RST:
0.1
Default unit: Seconds
SYSTem:SERRor?
Queries the next static error, if available. Static errors are more severe than normal
error conditions, which can be queried using
Normal errors result from, for example, unknown commands or syntax errors and gen-
erally affect a single parameter or setting. Static errors, as a rule, prevent the execution
of normal measurements.
Usage:
Query only
Configuring the System
