Rohde & Schwarz NRP TWG Series, Руководство пользователя

Страница: 53 / 128

Remote Control Commands
R&S
®
NRPxxTWG
53 User Manual 1178.8371.02 ─ 04
Parameters:
<master_port> EXT1 | EXTernal1 | EXT2 | EXTernal2
*RST:
EXT1
Example: TRIG:MAST:PORT EXT1
TRIG:SOUR EXT2
TRIG:MAST:STAT ON
Example: TRIG:MAST:PORT EXT2
TRIG:SOUR EXT1
TRIG:MAST:STAT ON
TRIGger:MASTer:STATe <state>
Enables or disables the trigger master mode of the sensor. In this state, the power sen-
sor can output a digital trigger signal in sync with its own trigger event.
If enabled, select the output port for the trigger signal using
TRIGger:MASTer:PORT
.
Typically, the trigger master uses its internal trigger source. But you can also trigger the
trigger master externally, because the power sensor has got two external trigger con-
nectors. If you trigger the trigger master externally, use
EXTernal1
as external trigger
input port (trigger source) and
EXTernal2
as trigger master output port or vice versa.
Parameters:
<state> *RST: OFF
TRIGger:SLOPe <slope>
Effective only if
TRIGger:SOURce
is set to
INTernal
or
EXTernal
.
Determines which edge of the envelope power, with internal triggering, or increasing
voltage, with external triggering, is used for triggering.
Parameters:
<slope> POSitive | NEGative
POSitive
Rising edge
NEGative
Falling edge
*RST:
POSitive
TRIGger:SOURce <source>
Selects the source for the trigger event detector.
Parameters:
<source> HOLD | IMMediate | INTernal | BUS | EXTernal | EXT1 |
EXTernal1 | EXT2 | EXTernal2
See
Chapter 7.5.2.3, "Trigger Sources" , on page 44.
*RST: IMMediate
Controlling the Measurement