Rohde & Schwarz NRP TWG Series, Руководство пользователя

Страница: 13 / 128

Preparing for Use
R&S
®
NRPxxTWG
13 User Manual 1178.8371.02 ─ 04
To disconnect from the DUT
►
NOTICE! Risk of damaging the center pin of the RF connector. Always rotate only
the hex nut of the RF connector. Never rotate the power sensor itself.
Carefully loosen the union nut at the front of the RF connector of the sensor and
remove the sensor.
3.5 Connecting to a Computer
For operating the power sensor, you can choose from various possibilities. For details,
see
Chapter 5, "Operating Concepts" , on page 19.
You can establish the connection using one of the following interfaces:
●
Host interface
Contents:
● Setting Up a USB Connection .................................................................................13
3.5.1 Setting Up a USB Connection
You can connect a R&S NRPxxTWG to a computer using the host interface and control
it as described in
Chapter 5, "Operating Concepts" , on page 19.
Further information:
●
Chapter 9.1, "Remote Control Interfaces and Protocols" , on page 100
3.5.1.1 Simple USB Connection
All R&S NRPxxTWG power sensors can be connected to a computer by a USB inter-
face and controlled by a supported software or a remote program.
Required equipment
●
R&S NRPxxTWG power sensor
●
R&S NRP
‑
ZKU cable
Connecting to a Computer