Operating Concepts
R&S
®
NRPxxTWG
22
User Manual 1178.8371.02 ─ 04
5.2
Remote Control
You can remote control the R&S NRPxxTWG easily. The change to remote control
occurs "on the fly" and has no influence on the manual operation.
Further information:
●
Chapter 7, "Remote Control Commands"
●
Chapter 9, "Remote Control Basics"
●
Chapter 9.1, "Remote Control Interfaces and Protocols"
●
Chapter 3.5, "Connecting to a Computer"
5.3
R&S NRPV
The R&S NRPV enables you to measure power in all available measurement modes.
Also, you can use up to four power sensors simultaneously.
The R&S NRPV is provided on your documentation CD-ROM and on the Rohde &
Schwarz website as a separate standalone installation package.
Required equipment
●
R&S NRPxxTWG power sensor
●
R&S NRP
‑
ZKU cable or an R&S NRP
‑
Z5 sensor hub and an R&S NRP
‑
ZK6 cable
to connect the sensor to the computer
●
Windows computer with installed:
–
R&S NRP Toolkit V
4.17 or higher
–
R&S NRPV version 3.2 or higher (refer to the operating manual of the R&S
NRPV for a description of the installation process)
Setup
Figure 5-1: Setup with an R&S NRPV
1 = Signal source
2 = R&S NRPxxTWG power sensor
3 = Host interface connector
4 = R&S NRP
‑
ZKU cable
5 = USB connector
6 = Computer with installed R&S NRPV
R&S NRPV