Rohde & Schwarz NRP TWG Series, Руководство пользователя

Страница: 42 / 128

Remote Control Commands
R&S
®
NRPxxTWG
42 User Manual 1178.8371.02 ─ 04
See also Chapter 7.7.1, "Continuous Average Measurement" , on page 57.
[SENSe<Sensor>:]FUNCtion <function>
Sets the measurement mode.
Parameters:
<function> "POWer:AVG"
Continuous Average
After a trigger event, the power is integrated over a time interval
(averaging) set using:
[SENSe<Sensor>:][POWer:][AVG:]APERture
.
*RST: "POWer:AVG"
7.5 Controlling the Measurement
The power sensor offers a bunch of possibilities to control the measurement:
●
Do you want to start the measurement immediately after the initiate command or
do you want to wait for a trigger event?
●
Do you want to start a single measurement cycle or a sequence of measurement
cycles?
●
Do you want to output each new average value as a measurement result or do you
want to bundle more measured values into one result?
7.5.1 Starting and Ending a Measurement
ABORt
............................................................................................................................ 42
INITiate:ALL
.................................................................................................................... 43
INITiate[:IMMediate]
......................................................................................................... 43
INITiate:CONTinuous
........................................................................................................43
ABORt
Immediately interrupts the current measurement. If the measurement has been started
as a single measurement (
INITiate[:IMMediate]
), the sensor goes into the idle
state. However, if a continuous measurement is in progress (
INITiate:CONTinuous
ON
), the trigger system of the sensor enters the waiting for trigger state, and if the trig-
ger condition is met, a new measurement is immediately started.
See also Chapter 7.5, "Controlling the Measurement" , on page 42.
Usage: Event
Controlling the Measurement