RKC INSTRUMENT Z-TIO-G, Инструкция по эксплуатации, Страница: 124 / 246

9. COMMUNICATION DATA DESCRIPTION
IMS01T28-E4
9-16
Remote/Local transfer
RKC communication
identifier C1
Modbus
register address ch1: 0069H (105)
ch2: 006AH (106)
Use to transfer the Remote mode or Local mode.
Local mode: Control is performed at the local set value (SV).
Remote mode: Control is performed with a remote setting (RS) input value or Cascade control.
Attribute:
R/W
Digits:
1 digit
Number of data:
2 (Data of each channel)
Data range:
0: Local mode
1: Remote mode
Factory set value:
0
Related parameters:
Operation mode state monitor (P. 9-5), SV tracking (P. 9-65)
When the cascade control is performed, the adjustment gauge on the slave must be switched to
Remote mode.
Link Z-TIO module and Z-DIO module to switch Remote/Local by using Digital input (DI). For
details, refer to following items:
 Address of interacting modules (P. 9-91)

Selection switch of interacting modules (P. 9-92)
 SRZ Instruction Manual (IMS01T04-E  )
RUN/STOP transfer
RKC communication
identifier SR
Modbus
register address 006DH (109)
Use to transfer the RUN (control RUN) or STOP (control STOP).
Attribute:
R/W
Digits:
1 digit
Number of data:
1 (Data of each module)
Data range:
0: Control STOP
1: Control RUN
Factory set value:
0
Related parameters:
Operation mode state monitor (P. 9-5), Operation mode (P. 9-37),
Control RUN/STOP holding setting (P. 9-94)
When used together with RKC panel mounted controllers (HA400/900, FB400/900, etc.), be
careful that the numbers of indicating “RUN/STOP” of this instrument are opposite from those of
the above controllers (0: Control RUN, 1: Control STOP).
Switch RUN/STOP by using Digital input (DI) of Z-DIO module. All modules connected to the
Z-DIO transfer RUN/STOP at the same time.
For details, refer to
SRZ Instruction Manual (IMS01T04-E  ).