Ridder Aqua CX300, Руководство пользователя

Страница: 58 / 92

Central: Reset the total water consumption of all valve groups.
All groups: Reset the registration data of all valve groups.
Group 1-3: Reset all registration data of a specific valve group.
3.3.2.2 Filter flushing
To enable filter flushing control, enter the following setting:
Set 'Flush filter' to 'Yes'.
Manual control
Filter program active
Period start time
Period end time
Flushing time
Delay after flushing
Litres for start flushing
Time active for start flush.
Path: Settings>General>Filter flushing
Manual control
None: Not active.
Start: Start filter flushing.
Stop: Stop filter flushing.
Pause: Pause filter flushing.
Filter flushing active
Enables you to activate automatic filter flushing.
No: Not active.
Yes: Active.
Start time of filter flushing
The filter will be flushed, as needed, between the start time and end time.
End time of filter flushing
The time after which the filter may no longer be flushed.
Flushing time
The length of time that the filter will be flushed with fresh water.
Delay time after flushing
After the filter has been flushed, the controller will wait until the time set here has
elapsed before the unit may be used for irrigation. If the filter is a sand filter, this
delay time enables the sand in the filter to settle again.
Litres for start flushing 0 - 99999999 Litres
The number of litres of water that must pass through for filter flushing to start.
Aqua CX300
58