Radyne ComStream TIERNAN SE4000, Инструкция по установке и эксплуатации

Страница: 88 / 161

SE4000 MPEG-2 Contribution Encoder Using a Remote Unit
01-0934-401-B 4-23
SE4000 Remote Command Descriptions
Remote Command Parameter
Range
Factory
Default
Description
TCA ENABLE Off, On Off Enables and disables PGCA at a system level.
Parameters are:
? on – enables PGCA; this setting ensures that
only those Tiernan decoders listed in the
PGCA database and authorized at an
individual level can receive the broadcast
signals.
? off – disables PGCA, all decoders, whether
authorized or not, can receive the broadcast
signal.
Note: PGCA is a proprietary conditional access
method used by Tiernan equipment that
provides basic signal protection and the ability
to authorize individual Tiernan IRDs. Non-
Tiernan IRDs cannot be authorized by PGCA;
therefore only authorized Tiernan IRDs can
decode a service that has been protected
through PGCA.
Note: For additional information on system-
level PGCA, or on adding, deleting and
authorizing individual decoders, refer to the
appendix on Conditional Access.
Note: PGCA cannot be enabled if BISS is
enabled.
Front panel command equivalent:
Config>CA>Setup>Service>Scramble> PGCA
TCA LIST - - Displays a list of all Tiernan decoders registered in
the PGCA database. The list includes the
decoder’s label, MAC address, and if the decoder
is authorized.
Front panel command equivalent:
Config>CA>PGCAcfg>Lst IRD
TCA MASK 0 to FF 0 Sets the PGCA scrambling key to a specified
algorithmic table.
Front panel command equivalent:
Config>CA>Setup>Service>Scramble>
PGCA>PGCA Key
TCA UPDATE - -
Loads the active subscriber list from the PGCA
database.
Front panel command equivalent: none
TCA UR 1 to 60
seconds
15
seconds
TCA update rate; specifies how often, in seconds,
PGCA information is transmitted.
Front panel command equivalent: none
TCA PID Sets or reads back the PID for PGCA messages
TCA SUB_CNT SUBSCRIBER COUNT
TCA BISS_EN
TCA BISS_HW
VAR <feature>
<key> 422_feature,
70_140_feature,
LBAND_feature,
8PSK_feature,
16QAM_feature
On the SE4000, various features are available as
keyed software upgrades. To purchase a software
upgrade contact Customer service. A software Key
will be provided. Entering the key enables the
feature.
VI.A FORMAT 525_lines
(NTSC)
625_lines
(PAL)
Read only Displays the format of the detected analog video
input.