Radyne ComStream TIERNAN SE4000, Инструкция по установке и эксплуатации

Страница: 8 / 161

Preface SE4000 MPEG-2 Contribution Encoder
viii 01-0934-401-B
LCD Display
When you receive your SE4000, the LCD display may be covered with a plastic protective
covering. To remove the protective covering, gently lift one of the corners and peel off the
covering.
Warranty Information
For warranty or return material authorization information, refer to the Warranty booklet that
accompanied the product shipment.
Other Tiernan Products
Visit the corporate website at www.radn.com. This provides information about the entire line of
Tiernan products and systems, including encoders, integrated receivers/decoders (IRD),
switches, ATM products, network interfaces, and network management software.
Safety Precautions
Carefully read and follow all safety, use, and operating instructions before operating the SE4000.
Heed all warnings and cautions contained in this manual. Retain these instructions for future
reference.
Follow Startup Procedure
Do not plug in the SE4000 until you have connected the system and read the chapter on
installation.
Provide a Safe Location
Place the SE4000 in a rack or on a stable surface of sufficient size and strength, where it will not
be jarred, hit, or pushed off its surface. Ensure that all cables and cords are out of the way and
will not be tripped over, as this could cause personal injury or serious damage to the equipment.
Avoid Water and Moisture
If the equipment is exposed to any liquid, contact Tiernan, as serious damage could occur to the
SE4000 or its components.
Avoid Heat, Humidity, and Dust
To avoid internal damage, the SE4000 should be placed away from all heat sources, including
radiators, heater ducts, and so on, out of direct sunlight and away from high humidity, excessive
dust, or mechanical vibrations that can cause damage to internal parts.