Radyne ComStream TIERNAN SE4000, Инструкция по установке и эксплуатации

Страница: 76 / 161

SE4000 MPEG-2 Contribution Encoder Using a Remote Unit
01-0934-401-B 4-11
SE4000 Remote Command Descriptions
Remote Command Parameter
Range
Factory
Default
Description
AXD.A BAUD 1200, 2400,
4800, 9600,
19200, 38400
bps
38400 bps Sets the asynchronous serial auxiliary data baud
rate.
Front panel command equivalent:
Config>Service>Data>Baud
AXD.B DR 1200 to
20,000,000
bps
1024000
bps Sets the data rate for the synchronous auxiliary
data channel.
Note: The data rate for the auxiliary data
channel reduces the total transport stream bit
rate available for the video signal; therefore, an
auxiliary data rate should be selected that
meets but does not exceed the site-specific
operational requirements.
Front panel command equivalent:
Config>Service>Data>Data Rate
AXD.< port > EN Off, On Off Enables or disables the auxiliary data channel in
the transport stream. Parameters are:
? Off = auxiliary data is not included in the
transport stream
? On = auxiliary data is included in the transport
stream.
Front panel command equivalent:
Config>Service>Data>Enable
AXD.A PARITY N, O, E N Sets the parity bit for asynchronous serial
communication. Parameters are:
N = none, O = odd, E = even.
Front panel command equivalent:
Config>Service>Data>Parity
AXD.B SRC INT, EXT INT Sets the clock source for the synchronous auxiliary
data channel; parameters are:
? INT = internal, uses ST to latch the data.
? EXT = external, uses TT to
latch the data.
AXD SRC is only available when AXD Mode is set
to sync.
Front panel command equivalent:
Config>Service>Data>Clock Source
AXD.A STOP 1, 2 1 Sets the number of stop bits for the asynchronous
serial protocol.
Front panel command equivalent:
Config>Service>Data>Stop Bits
AXD.A WIDTH 7,8 8 Sets the number of data bits for asynchronous
serial data.
Front panel command equivalent:
Config>Service>Data>Data Bits
AXD.A FC NONE, HARD None Sets the flow control for asynchronous serial data.
Front panel command equivalent:
Config>Service>Data>flow control
CM DELETE
<
string >
Where string
specifies a
user-defined
label.
- Deletes the specified user-defined configuration.
CM DUMP - - Displays the complete list of parameters in the
SE4000. A sample Configuration dump is shown at
the end of this guide.
This process takes several
seconds to display the entire configuration
dump.
CM LIST - - Query-only. Displays a list of all current
configuration labels.