Radyne ComStream TIERNAN SE4000, Инструкция по установке и эксплуатации

Страница: 132 / 161

SE4000 MPEG-2 Contribution Encoder Conditional Access
TM103 – Rev. 1.3 C
-
3
C.4 Configuring BISS from a Remote Unit
Before beginning to configure the encoder for BISS conditional access, remote unit with a
communications program installed, such as ProComm must be present.
Connect to a Remote Unit
1.
Ensure that the remote unit has a communications program installed, such as ProComm.
2.
Connect an RS-232 cable from the PC COM port 1 to the SE4000 RS-232 port.
3.
Start the ProComm software. Configure ProComm to communicate via COM port 1 at a
baud rate of 38400 bps.
4.
Power on the encoder.
5.
Wait for the main menu to display on the encoder’s front panel.
6.
ProComm should display various messages and then end with the prompt >.
If the > prompt does not display, flip the DCE/DTE switch on the back of the SE4000 to
the other position. Press the Enter key on the keyboard several times. The > prompt
should display .
Configure BISS Parameters
1.
Review the current BISS configuration parameters for all active services. Type mux
prog_info and press Enter. The current conditional access settings for all services is
displayed. Information includes: program number, program name, previous scrambling
mode, current scrambling mode, and the key.
2.
Enable BISS for a service. Type mux scram_en < service# > mode_1 and press Enter.
This command enables BISS scrambling mode 1 for the service number entered in the
<service#> parameter.
3.
Enter the Scramble key for the selected service. Type mux scram_key < service# > <key>
and press Enter. This command sets the BISS scrambling key for the service number
entered in the
<service#> parameter. The key is a 12-digit hexadecimal number.
4.
Disable BISS for any services, as required. Type mux scram_en < service# > off and
press Enter.
5.
Review the current BISS configuration parameters for all active services to ensure that all
BISS settings are correct. Type mux prog_info and press Enter.
6.
Enable BISS at the system level. Type mux biss_en on and press Enter.
BISS cannot be enabled if PGCA is enabled.