6100-Gfast Multifunction Copper Tester Operation Manual
© 2020 Radiodetection Ltd
161
The IPv6
LAN Setup
tab is available only in
Manual
Test Setup
and when the
Access Mode
set in
Connection Setup
is set to
IPv6 (DHCP)
. This page
allows you to Enable/Disable Pass Through Mode
when the LAN (local area network) is connected to the
external device which supports 10/100/1000 Ethernet.
Pass Through Mode is renamed
LAN Port
.
To set the parameter:
1. Press the left/right arrow keys to toggle
between
Enable/Disable
.
OR
2. Press
on any value to open the list box to
toggle between
Enable/Disable
by pressing
the up/down arrow keys.
3. Press
to confirm your selection.
Thresholds
The
Thresholds
tab allows you to define DSL
parameter criteria. For
D/S
(downstream) and
U/S
(upstream) data rates, there are
OK
and
Min
(minimum) bit rates defined to indicate unacceptable,
marginal, and acceptable rates.
D/S
and
U/S OK bit rate
:
o
for ADSL - value limited to D/S 30
Mbit/s, U/S 2 Mbit/s.
o
for VDSL - D/S to 100 Mbit/s, U/S to 50
Mbit/s.
o
for G.fast - D/S and U/S maximum
value set to 1000 Mbit/s.
o
for VDSL2-35b - D/S can be 350
Mbit/s, U/S is 50 Mbit/s.
D/S
and
U/S Min SNR margin
- values range
from 0 to 63.5 dB. Default is 5 dB.
D/S
and
U/S Max Attenuation
- values range
from 0 to 96 dB. Default is 10 dB.
Sync Loss Counter
is the number of times the
unit lost synchronization.
Bonding Criteria
allows you to select either
Single Line
/
Both Lines Connected &
Bonded
to check the pass/fail criteria of the
DSL lines in bonding mode.
To set threshold values:
1. Press the up/down arrows to select the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open the
alphanumeric editor screen and use the
navigation keys to scroll through.
4. Press
to confirm the value.
5. If you make any changes to the parameter
values, press the on-screen function keys to
save or cancel your input.
Select Tests
